Advanced search
46 search results
Page 2 out of 5 Pages
- ROV Systems: How does the Pro 4 measure water temperature? Answer: The Pro 4 uses a precision piezoresistive sensor for water pressure and temperature measurement.Both datum are measured by a single sensing element which is in ...
- ROV Systems: How long a tether can a VideoRay use? Answer: Presuming that most of the length is negative tether The Pro 3 can support up to 1250 feet (381 meters.) The Pro 4 with a Lyyn ...
- ROV Systems: How much Power does VideoRay have to pull tethers and fight currents? Answer: Different VideoRays produce different amounts of thrust. We'll answer this question for the model with the most thrust, the Pro 4. Tether pulling ability is a ...
- Product Information: How Stable is a VideoRay in the water? Answer: Underwater stability could be defined in two ways: When moving slowly or when stationary, what happens as it is hit by swirling water currents? When being driven, ...
- Turner Designs: I already own a Turner Designs C3. Can I integrate it with a VideoRay ROV? Answer: Yes, you will need to purchase a VideoRay Pro 4 and C3 Integration Kit. ...
- Turner Designs: I already own a VideoRay ROV. Can I integrate it with a C3? Answer: Yes, as long as the VideoRay you own is a Pro 4. You will need to purchase a C3 and desired sensors and a C3 ...
- Personal Safety: Is it safe to be in the water with a VideoRay? Answer: VideoRay systems include built-in GFCI protection. VideoRay models below the Pro 4 use 48 Volts DC in the tether. The Pro 4 uses 75 Volts DC in ...
- ROV Systems: Is the VideoRay suitable for use in a nuclear environment? Answer: Both the Pro 3 and Pro 4 systems have been used extensively in nuclear power stations and decommissioning sites around the UK. These are highly ...
- Turner Designs: Is training for the VideoRay Pro 4 and Turner Designs C3 available? Answer: Yes, training for operators and technicians interested in using the VideoRay Pro 4 and C3 Fluoromter is available. Contact VideoRay or Turner Designs for more ...
- Diagnostics and Repair: My Pro 3 manipulator doesnt seem to work. What can I do to isolate the Answer: There are four likely reasons for a manipulator to stop working. A jammed jaw mechanism. A broken motor. Loss of power at the accessory port. A short or break ...